The Obvious Difference Between A Sink Plunger And A Toilet Plunger
You will see the only difference between these two plungers is the flange. The rubber piece is found inside the rubber cup and can come in many shapes. They all serve the same purpose: to seal the drainpipe and provide a greater sucking force.
The flange also prevents the plunger’s filling with water from the toilet. You may have used a sink plunger if you’ve ever had to flip it upside down after making a few thrusts. Because they don’t have a flange and can seal on any flat surface, their design makes them great for sinks, but pretty useless for toilets.
Why Should You Have Separate Plungers?
Sink plungers will not work for toilets, as we have already mentioned. They will only move the water, but not remove the blockage. Toilet plungers can be used to remove blockages in sinks but this is not always a good idea. It is not safe to use your toilet plunger for cleaning clogs in your sink if it isn’t kept clean. Separate plungers are a good idea. It’s even better to purchase them in different colors to avoid confusion.
How To Remove A Clog From A Sink Using A Plunger
Most people have used a toilet plunger in their lifetime. However, when it comes down to tubs and sinks, most people prefer to use plumbing snakes. If nothing works, it’s time to use a sink plunger. Both tubs and sinks can be unclogged the same way.
Locate the overflow hole, which is located near the sink. This will seal the air hole and make sure that the plunger is sealed properly. Place the plunger on the hole, and let the water run for a few minutes until the rubber cup becomes covered. Then pump the plunger several times and then lift it up to check for water drainage.
Pump the water a few times more until it is flowing smoothly. Run hot water for a few more minutes to clear the rest of the clog.
How To Remove A Clog From A Toilet With A Plunger
It is much easier than you think to unclog a toilet using a plunger. To prevent your toilet from overflowing, turn off the water supply to your toilet before you begin. Cover the drain with a plunger. However, make sure the water does not reach more than half the rubber flange. Pour more water if you don’t have enough. However, make sure the plunger seals completely.
Push it down and then push it up. But don’t break the seal. It will create a vacuum which should eventually clear the clog if it is done correctly. Make sure you repeat the action at least once more times with the plunger. You should also use safety glasses and gloves if chemicals were poured down the toilet. It might splash. Push the plunger down, then push it up hard. This will break the seal, and you can remove the plunger. Flush the toilet to see if it is still blocked. If the toilet is still clogged, flush it again.
What Is An Accordion Plunger?
Although they are not as well-known as toilet and sink plungers, accordion plungers can produce a lot of force. They are made of plastic and can be a little difficult to use. They are not made of rubber so sometimes they won’t fit in the toilet. You might scratch the surface if your accordion plunger is too rough.